AN4206 datasheet(24/34 Pages) STMICROELECTRONICS

24 / 34 page

Recommendations

AN4206

24/34

DocID023944 Rev 4

Recommendations

5.1

Printed circuit board

For technical reasons, it is best to use a multilayer printed circuit board (PCB) with a

separate layer dedicated to ground (VSS) and another dedicated to the VDD supply. This

provides good decoupling and a good shielding effect. For many applications, economic

reasons prohibit the use of this type of board. In this case, the major requirement is to

ensure a good structure for ground and for the power supply.

5.2

Component position

A preliminary layout of the PCB must make separate circuits:



High-current circuits



Low-voltage circuits



Digital component circuits



Circuits separated according to their EMI contribution. This will reduce cross-coupling

on the PCB that introduces noise

5.3

Ground and power supply (VSS, VDD, VSSA, VDDA, VSSSD,

VDDSD)

All blocks such as, for example noisy, low-level sensitive and digital should be grounded

individually and all ground returns should be to a single point. Loops must be avoided or

have a minimum area. The power supply should be implemented close to the ground line to

minimize the area of the supply loop. This is due to the fact that the supply loop acts as an

antenna, and is therefore the main transmitter and receiver of EMI. All component-free PCB

areas must be filled with additional grounding to create a kind of shielding (especially when

using single-layer PCBs).

5.4

Decoupling

All power supply and ground pins must be properly connected to the power supplies. These

connections, including pads, tracks and vias should have as low an impedance as possible.

This is typically achieved with thick track widths and, preferably, the use of dedicated power

supply planes in multilayer PCBs.

In addition, each power supply pair should be decoupled with 100 nF filtering ceramic

capacitors and a chemical capacitor of about 4.7 µF connected between the supply pins of

the STM32F3xx device. These capacitors need to be placed as close as possible to, or

below, the appropriate pins on the underside of the PCB. Typical values are 10 nF to 100 nF,

but exact values depend on the application needs. Figure 12 shows the typical layout of

such a VDD/VSS pair.

AN4206 Datasheet(PDF) 24 Page - STMicroelectronics

AN4206 Datasheet(HTML) 24 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Datasheet Download

Link URL