SL13A-ASWB datasheet(18/49 Pages) AMSCO

18 / 49 page

SL13A – 18

ams Datasheet: 2014-May-06 [v1-01]

C o mmands

• Set External Calibration Data - #17

The SET-EXT-CAL-DATA command sets the user

calibration values. Those values have no effect on the

internal calibration settings.

Security level 1.

• Set Internal Calibration Data - #18

The SET-INT-CAL-DATA command sets the calibration

values for the internal temperature sensor.

Security level 1.

• Set Passive - #19

The SET-PASSIVE command stops the logging procedure

and returns the chip to passive mode. It also stops the

timer.

Security level 1.

• Start Log - #20

The START-LOG command starts the logging procedure

and sets the Start time in UTC format. In logging state the

chips automatically performs the measurements and data

logging in the specified time intervals. Supported is also

a delayed start, which means that the chip will start with

the logging procedure with a specified delay after it

receives the START-LOG command.

Security level 1.

• Get Log State - #21

The GET-LOG-STATE command gets the log state of

following parameters: measurement status and out of

limits counter. This gives the ability to quickly check the

state of the package without the need to read the whole

temperature data log.

•Get Calibration Data - #22

The GET-CALIBRATION command reads the calibration

data for the internal and external sensors.

• Get Battery Level - #23

The GET-BAT-LEVEL command measures and reads the

voltage level of the battery.

•Verify PW - #24

The VERIFY-PW command is used to verify the various

passwords.

SL13A-ASWB Datasheet(PDF) 18 Page - ams AG