SC68C752B datasheet(18/49 Pages) PHILIPS

18 / 49 page

SC68C752B_3

Product data sheet

Rev. 03 — 29 November 2005

18 of 49

Philips Semiconductors

SC68C752B

5 V, 3.3 V and 2.5 V dual UART, 5 Mbit/s (max.), with 64-byte FIFOs

6.8 Break and time-out conditions

An RX idle condition is detected when the receiver line, RX, has been HIGH for

4 character time. The receiver line is sampled midway through each bit.

When a break condition occurs, the TX line is pulled LOW. A break condition is activated

by setting LCR[6].

6.9 Programmable baud rate generator

The SC68C752B UART contains a programmable baud generator that takes any clock

input and divides it by a divisor in the range between 1 and (216

− 1). An additional

divide-by-4 prescaler is also available and can be selected by MCR[7], as shown in

Figure 12. The output frequency of the baud rate generator is 16

× the baud rate. The

formula for the divisor is:

Where:

prescaler = 1, when MCR[7] is set to 0 after reset (divide-by-1 clock selected)

prescaler = 4, when MCR[7] is set to 1 after reset (divide-by-4 clock selected).

Remark: The default value of prescaler after reset is divide-by-1.

Figure 12 shows the internal prescaler and baud rate generator circuitry.

DLL and DLH must be written to in order to program the baud rate. DLL and DLH are the

least signiﬁcant and most signiﬁcant byte of the baud rate divisor. If DLL and DLH are both

zero, the UART is effectively disabled, as no baud clock will be generated.

Remark: The programmable baud rate generator is provided to select both the transmit

and receive clock rates.

Table 8 and Table 9 show the baud rate and divisor correlation for crystal with frequency

1.8432 MHz and 3.072 MHz, respectively.

Figure 13 shows the crystal clock circuit reference.

Fig 12. Prescaler and baud rate generator block diagram

divisor

XTAL1 crystal input frequency

prescaler

---------------------------------------------------------------------------





desired baud rate

()

---------------------------------------------------------------------------------

BAUD RATE

GENERATOR

LOGIC

MCR[7] = 1

MCR[7] = 0

PRESCALER

LOGIC

(DIVIDE-BY-1)

INTERNAL

OSCILLATOR

LOGIC

002aaa233

XTAL1

XTAL2

input clock

PRESCALER

LOGIC

(DIVIDE-BY-4)

reference

clock

internal

baud rate

clock for

transmitter

and receiver

SC68C752B Datasheet(PDF) 18 Page - NXP Semiconductors

SC68C752B Datasheet(HTML) 18 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

Datasheet Download

Link URL