ASX340 datasheet(31/78 Pages) ETC2

31 / 78 page

PDF: 171981479/Source: 8304342517

Aptina reserves the right to change products or specifications without notice.

ASX340/MT9V139_DS Rev. C Pub. 3/11 EN

ASX340/MT9V139: 1/4-Inch Color CMOS NTSC/PAL Digital Image Sensor

External Signal Processing

Aptina Confidential and Proprietary

Preliminary

Device Configuration

After power is applied and the device is out of reset by de-asserting the RESET_BAR pin,

it will enter a boot sequence to configure its operating mode. There are essentially three

configuration modes: Flash/EEPROM Config, Auto Config, and Host Config. Figure 19:

“Power-Up Sequence – Configuration Options Flow Chart,” on page 32 contains more

details on the configuration options.

The SOC firmware supports a System Configuration phase at start-up. This consists of

five modes of execution:

1. Flash Detection

2. Flash-Config

3. Auto-Config

4. Host-Config

5. Change-Config (commences streaming - completes the System Configuration mode).

The System Configuration phase is entered immediately after the firmware initializes

following SOC power-up or reset. By default, the firmware first enters the Flash Detec-

tion mode

The Flash Detection mode attempts to detect the presence of an SPI Flash or EEPROM

device:

• If no device is detected, the firmware then samples the SPI_SDI pin state to determine

the next mode:

– If SPI_SDI == 0 then it enters the Host-Config mode.

– If SPI_SDI == 1 then it enters the Auto-Config mode.

• If a device is detected, the firmware switches to the Flash-Config mode.

In the Flash-Config phase, the firmware interrogates the device to determine if it

contains valid configuration records:

• If no records are detected, then the firmware enters the Auto-Config mode.

• If records are detected, the firmware processes them. By default, when all Flash

records are processed the firmware switches to the Host-Config mode. However, the

records encoded into the Flash can optionally be used to instruct the firmware to

proceed to one of the other mode (auto-config/change-config).

The Auto-Config mode uses the FRAME_VALID, LINE_VALUE, DOUT_LSB0 and

DOUT_LSB1 pins to configure the operation of the device, such as video format and

pedestal (see Table 16, “GPIO Bit Descriptions,” on page 33). After Auto-Config

completes the firmware switches to the Change-Config mode.

In the Host-Config mode, the firmware performs no configuration, and remains idle

waiting for configuration and commands from the host. The System Configuration

phase is effectively complete and the SOC will take no actions until the host issues

commands.

In the Change-Config mode, the firmware performs a 'Change-Config' operation. This

applies the current configuration settings to the SOC, and commences streaming. This

completes the System Configuration phase.

ASX340 Datasheet(PDF) 31 Page - List of Unclassifed Manufacturers

ASX340 Datasheet(HTML) 31 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78

Datasheet Download

Link URL