7545 datasheet(9/62 Pages) RENESAS

9 / 62 page

Rev.1.06

Mar 07, 2008

Page 9 of 59

REJ03B0140-0106

7545 Group

FUNCTIONAL DESCRIPTION

Central Processing Unit (CPU)

The MCU uses the standard 740 family instruction set. Refer to

the table of 740 family addressing modes and machine-language

instructions or the SERIES 740 <SOFTWARE> USER’S

MANUAL for details on each instruction set.

Machine-resident 740 family instructions are as follows:

1. The FST and SLW instructions cannot be used.

2. The MUL and DIV instructions can be used.

3. The WIT instruction can be used.

4. The STP instruction can be used.

This instruction cannot be used while CPU operates by an on-

chip oscillator.

[Accumulator (A)]

The accumulator is an 8-bit register. Data operations such as data

transfer, etc., are executed mainly through the accumulator.

[Index register X (X), Index register Y (Y)]

Both index register X and index register Y are 8-bit registers. In

the index addressing modes, the value of the OPERAND is

added to the contents of register X or register Y and specifies the

real address.

When the T flag in the processor status register is set to “1”, the

value contained in index register X becomes the address for the

second OPERAND.

[Stack pointer (S)]

The stack pointer is an 8-bit register used during subroutine calls

and interrupts. The stack is used to store the current address data

and processor status when branching to subroutines or interrupt

routines.

The lower eight bits of the stack address are determined by the

contents of the stack pointer. The upper eight bits of the stack

address are determined by the Stack Page Selection Bit. If the

Stack Page Selection Bit is “0”, then the RAM in the zero page is

used as the stack area. If the Stack Page Selection Bit is “1”, then

RAM in page 1 is used as the stack area.

The Stack Page Selection Bit is located in the SFR area in the

zero page. Note that the initial value of the Stack Page Selection

Bit varies with each microcomput er type. Al so some

microcomputer types have no Stack Page Selection Bit and the

upper eight bits of the stack address are fixed. The operations of

pushing register contents onto the stack and popping them from

the stack are shown in Figure 8.

[Program counter (PC)]

The program counter is a 16-bit counter consisting of two 8-bit

registers PCH and PCL. It is used to indicate the address of the

next instruction to be executed.

Fig. 7 740 Family CPU register structure

PCL

Processor Status Register (PS)

Carry Flag

b15

PCH

Zero Flag

Interrupt Disable Flag

Decimal Mode Flag

Break Flag

Index X Mode Flag

Overflow Flag

Negative Flag

Program Counter

Stack Pointer

Index Register Y

Index Register X

Accumulator

7545 Datasheet(PDF) 9 Page - Renesas Technology Corp

7545 Datasheet(HTML) 9 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

Datasheet Download

Link URL