12

MACH211SP-7/10 (Com’l)

Notes:

1. These parameters are not 100% tested, but are evaluated at initial characterization and at any time the design is modified

where frequency may be affected.

2. See Switching Test Circuit for test conditions.

3. If a signal is powered-down, this parameter must be added to its respective high-speed parameter.

Input Latch Gate to Output Latch Setup

10

11

ns

Input Latch Gate Width LOW

3

5

ns

Input, I/O, or Feedback to Output Through Transparent Input and

Output Latches

12.5

14

ns

Asynchronous Reset to Registered or Latched Output

9.5

15

ns

Asynchronous Reset Width (Note 1)

5

10

ns

Asynchronous Reset Recovery Time (Note 1)

5

10

ns

Asynchronous Preset to Registered or Latched Output

9.5

15

ns

Asynchronous Preset Width (Note 1)

5

10

ns

Asynchronous Preset Recovery Time (Note 1)

5

10

ns

Input, I/O, or Feedback to Output Enable (Note 1)

9.5

12

ns

Input, I/O, or Feedback to Output Disable (Note 1)

9.5

12

ns

10

10

ns

10

10

ns

0

0

ns

10

10

ns

SWITCHING CHARACTERISTICS over COMMERCIAL operating ranges (Note 2)

(continued)

Parameter

Symbol

Parameter Description

-7

-10

Unit

Min

Max

Min

Max