+

-

LMP7707, LMP7708, LMP7709

SNOSAW5B – JUNE 2007 – REVISED MARCH 2013

www.ti.com

APPLICATION INFORMATION

LMP7707/LMP7708/LMP7709

The LMP7707/LMP7708/LMP7709 devices are single, dual and quad low offset voltage, rail-to-rail input and

output precision amplifiers each with a CMOS input stage and the wide supply voltage range of 2.7V to 12V. The

LMP7707/LMP7708/LMP7709 have a very low input bias current of only ±200 fA at room temperature.

The wide supply voltage range of 2.7V to 12V over the extensive temperature range of

−40°C to 125°C makes

either the LMP7707, LMP7708 or LMP7709 an excellent choice for low voltage precision applications with

extensive temperature requirements.

The LMP7707/LMP7708/LMP7709 have only ±37 µV of typical input referred offset voltage and this offset is

ensured to be less than ±500 µV for the single and ±520 µV for the dual and quad over temperature. This

minimal offset voltage allows more accurate signal detection and amplification in precision applications.

The low input bias current of only ±200 fA along with the low input referred voltage noise of 9 nV/

√Hz give the

LMP7707/LMP7708/LMP7709 superior qualities for use in sensor applications. Lower levels of noise introduced

by the amplifier mean better signal fidelity and a higher signal-to-noise ratio.

The LMP7707/LMP7708/LMP7709 are stable for a gain of 6 or higher. With proper compensation though, the

LMP7707, LMP7708 or LMP7709 can be operational at a gain of ±1 and still maintain much faster slew rates

than comparable fully compensated amplifiers. The increase in bandwidth and slew rate is obtained without any

additional power consumption.

Texas Instruments is heavily committed to precision amplifiers and the market segment they serve. Technical

support and extensive characterization data is available for sensitive applications or applications with a

constrained error budget.

The LMP7707 is offered in the space-saving 5-pin SOT-23 and 8-pin SOIC packages, the LMP7708 comes in the

8-pin VSSOP and 8-pin SOIC packages, and the LMP7709 is offered in the 14-pin TSSOP and 14-pin SOIC

packages. These small packages are ideal solutions for area constrained PC boards and portable electronics.

CAPACITIVE LOAD

The LMP7707/LMP7708/LMP7709 devices can each be connected as a non-inverting voltage follower. This

configuration is the most sensitive to capacitive loading.

The combination of a capacitive load placed on the output of an amplifier along with the amplifier’s output

impedance creates a phase lag which in turn reduces the phase margin of the amplifier. If the phase margin is

significantly reduced, the response will be either underdamped or it will oscillate.

be used. By using this isolation resistor, the capacitive load is isolated from the amplifier’s output, and hence, the

Figure 45. Isolating Capacitive Load

16

Submit Documentation Feedback

Copyright © 2007–2013, Texas Instruments Incorporated

Product Folder Links: LMP7707 LMP7708 LMP7709