CS5376A datasheet(32/107 Pages) CIRRUS

32 / 107 page

CS5376A

9. CONFIGURATION BY MICROCONTROLLER

After reset, the CS5376A reads the state of the

BOOT pin to determine a source for configuration

commands. If BOOT is low, the CS5376A receives

configuration commands from a microcontroller.

9.1 Pin Descriptions

Pins required for microcontroller boot are listed

here, other SPI 1 pins are inactive.

SSI - Pin 49

Slave select input pin, active low. Serial chip select

input from a microcontroller.

SCK1 - Pin 48

Serial clock input pin. Serial clock input from mi-

crocontroller, maximum 4.096 MHz.

MOSI - Pin 51

Serial data input pin. Valid on rising edge of SCK1,

transition on falling edge.

MISO - Pin 50

Serial data output pin. Valid on rising edge of

SCK1, transition on falling edge. Open drain out-

put requiring a 10 k

Ω pull-up resistor.

SINT - Pin 52

Serial interrupt output pin, active low. 1 uS active

low pulse output when ready for next serial trans-

action.

9.2 Microcontroller Hardware Interface

When

booting

from

microcontroller

the

CS5376A SPI 1 port receives configuration com-

mands and configuration data through serial trans-

actions, as shown in Figure 18. 8-bit SPI opcodes

and 8-bit addresses are combined to read and write

24-bit configuration commands and data.

Microcontroller serial transactions require toggling

the SSI pin as the CS5376A chip select and writing

a serial clock to the SCK1 input. Serial data is input

to the CS5376A on the MOSI pin, and output from

the CS5376A on the MISO pin.

9.3 Microcontroller Serial Transactions

Microcontroller configuration commands are writ-

ten to the digital filter through the SPI 1 registers.

A 24-bit command and two 24-bit data words can

be written to the SPI 1 registers in any single serial

transaction. Some commands require additional

data words through additional serial transactions to

complete.

9.3.1

SPI opcodes

microcontroller

communicates

with

the

CS5376A SPI 1 port using standard 8-bit SPI op-

codes and an 8-bit SPI address. The standard SPI

‘Read’ and ‘Write’ opcodes are listed in Figure 18.

SCK1

MISO

MOSI

Pin Logic

SPI 1

Figure 17. Serial Peripheral Interface 1 (SPI 1) Block Diagram

SINT

Command

SSI

Registers

Digital Filter

Interpreter

SPI 1

CS5376A Datasheet(PDF) 32 Page - Cirrus Logic

CS5376A Datasheet(HTML) 32 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL