RYZ024A

Datasheet

R19DS0115EU0101 Rev.1.01

Page 22 of 38

Nov.14.22

Regulatory Information

This section contains general regulatory information.

FCC Regulatory Approval

FCC-ID: 2AU6XRZ024A (single modular approval)

This above identified LTE radio module is not intended to be provided to end-users but is for installation by

OEM integrators only.

Installation/Integration

OEM integrators must follow Renesas installation instructions to provide for and benefit from FCC compliant

module integrations and must abide especially by the following provisions:

The maximum antenna gain values (accounting for cable attenuation) to comply with the FCC maximum

ERP/EIRP limits and with RF Exposure rules:

•

LTE band 2 (1900 PCS): 8.0 dBi

•

LTE band 4 (AWS-1): 5.0 dBi

•

LTE band 5 (850): 9.4 dBi

•

LTE band 12 (700a): 8.6 dBi

•

LTE band 13 (700c): 9.1 dBi

•

LTE band 17 (700b): 8.7 dBi

•

LTE band 25 (1900+): 8.0 dBi

•

LTE band 66 (AWS-3): 5.0 dBi

The Renesas’ module integration guidelines must be closely followed.

Compliance of host integrations of the module is limited to hosts adaptation designs which are identical to

Renesas’ reference design.

Host integrations with adaption designs deviating from Renesas’ reference design require either class 2

permissive change to this modular approval or a separate host approval with different FCC-ID;

Host integrations with co-located (simultaneously operating) radio transmitters must be evaluated in

accordance with FCC multi-transmitter rules and may require either class 2 permissive change to this

modular approval or a separate host approval with different FCC-ID, dependent on the result of the

evaluation; Inquiry at FCC or a TCB is urgently recommended.

Integrations of the module into host products which are intended for portable use, i.e. less than 20cm

distance between its radiating structures (antenna) and the body of nearby persons, or which otherwise put

additional technical requirements like Hearing Aid compatibility require either class 2 permissive change to

this modular approval or a separate host approval with different FCC-ID;

Compliance with Unwanted Emission Limits for Digital Device

If the OEM host integration fully complies with the above described reference design and can completely

inherit and rest on compliance of the existing modular approval the OEM remains still responsible to show

compliance of the overall end-product with the FCC limits for unwanted conducted and radiated emissions

from the digital device.

End-product Labelling

•

FCC-ID

The module’s FCC-ID must either be visible from the exterior of the host product (e.g. per window) or per

electronic display, or shall be displayed on an additional exterior label per the following or similar string:

contains FCC-ID: 2AU6XRZ024A

•

Digital Device – Unwanted Emissions Notice

If the end-product falls under part 15 of the FCC rules (it shall display the following user notice on its exterior

acc. To part 15.19 (the notice may be printed in the manual in case the host is too small):

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference, and