R8C13 datasheet(60/224 Pages) RENESAS

60 / 224 page

Rev.1.20

Jan 27, 2006

page 49 of 205

REJ09B0111-0120

R8C/13 Group

10.1.3 Hardware Interrupts

Hardware interrupts are classified into two types — special interrupts and peripheral function inter-

rupts.

(1) Special Interrupts

Special interrupts are non-maskable interrupts.

• Watchdog Timer Interrupt

Generated by the watchdog timer. Once a watchdog timer interrupt is generated, be sure to initialize

the watchdog timer. For details about the watchdog timer, refer to Chapter 11, “Watchdog Timer.”

• Oscillation Stop Detection Interrupt

Generated by the oscillation stop detection function. For details about the oscillation stop detection

function, refer to Chapter 6, “Clock Generation Circuit.”

• Voltage Detection Interrupt

Generated by the voltage detection circuit. For details about the voltage detection circuit, refer to

Section 5.4, “Voltage Detection Circuit.”

• Single-step Interrupt

Do not normally use this interrupt because it is provided exclusively for use by development support

tools.

• Address Match Interrupt

An address match interrupt is generated immediately before executing the instruction at the address

indicated by the RMAD0 to RMAD1 register that corresponds to one of the AIER register's AIER0 or

AIER1 bit which is "1" (address match interrupt enabled). For details about the address match inter-

rupt, refer to Section 10.4, “Address Match Interrupt.”

(2) Peripheral Function Interrupts

Peripheral function interrupts are maskable interrupts and generated by the microcomputer's internal

functions. The interrupt factors for peripheral function interrupts are listed in Table 10.2.

“Relocatable Vector Tables”. For details about the peripheral functions, refer to the description of

each peripheral function in this manual.

10.1 Interrupt Overview

R8C13 Datasheet(PDF) 60 Page - Renesas Technology Corp