822-1002-C01 datasheet(18/40 Pages) MAGNETROL

18 / 40 page

DNRG

FALT

YES

CAL

IGNR

ENT

STEP 7

STEP 8

STEP 7: FALT (Fault)

1. FALT (fault) refers to the choice of the alarm relay to DNRG

(de-energize) or IGNR (ignore) upon diagnosing a fault.

NOTE: The dedicated diagnostic Relay 1 will always de-energize

when a fault is detected.

When FALT is displayed, press ENT

to display DNRG.

2. If this is the desired condition, press ENT

to display

CAL.

3. If IGNR is desired, use the UP

or DOWN

arrow key to toggle between the selections.

4. When the appropriate selection is displayed, press ENT

to lock in the value and display CAL.

STEP 8: CAL (Calibration)

1. After modifying any or all of the preceding values, CAL

will lock in all the values and store them in memory.

Press ENT

to display NO (do not calibrate).

2. Press ENT

if it is desired to leave current values.

3. If new values are desired, use the UP

and DOWN

arrow keys to toggle to YES (calibrate).

4. Press ENT

to lock all the new values in memory and

return to the RUN mode.

NOTE: Ensure that the level of the process media is at the exact point

that corresponds to the choice made in Step 1 LEVL:DRY (not

covered with media) or WET (covered with media). This is crit-

ical to the proper calibration of the instrument. The unit will

take a new capacitance reading (establish a new set point)

when YES is chosen and ENT

is depressed.

ENT

50-621 Kotron Sentinel Models 822, 832 and 842 RF Point Level Switches

822-1002-C01 Datasheet(PDF) 18 Page - Magnetrol International, Inc.

822-1002-C01 Datasheet(HTML) 18 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Datasheet Download

Link URL