OR4 datasheet(104/152 Pages) LATTICE

104 / 152 page

104

Lattice Semiconductor

Data Sheet

May, 2006

ORCA Series 4 FPGAs

Pin Information (continued)

Table 65. Pin Descriptions

(continued)

Symbol

I/O

Description

Special-Purpose Pins

(continued)

DIN

During slave serial or master serial conﬁguration modes, DIN accepts serial conﬁguration

data synchronous with CCLK. During parallel conﬁguration modes, DIN is the D0 input. Dur-

ing conﬁguration, a pull-up is enabled.

I/O After conﬁguration, this pin is a user-programmable I/O pin.*

DOUT

O During conﬁguration, DOUT is the serial data output that can drive the DIN of daisy-chained

slave devices. Data out on DOUT changes on the rising edge of CCLK.

I/O After conﬁguration, DOUT is a user-programmable I/O pin.*

TESTCFG

During conﬁguration this pin should be held high, to allow conﬁguration to occur. A pull up is

enabled during conﬁguration.

I/O After conﬁguration, TESTCFG is a user programmable I/O pin.*

* The FPGA States of Operation section contains more information on how to control these signals during start-up. The timing of DONE release

is controlled by one set of bit stream options, and the timing of the simultaneous release of all other conﬁguration pins (and the activation of all

user I/Os) is controlled by a second set of options.

OR4 Datasheet(PDF) 104 Page - Lattice Semiconductor