L6482 datasheet(41/73 Pages) STMICROELECTRONICS

41 / 73 page

L6482

Serial interface

Doc ID 023768 Rev 2

41/73

Serial interface

The integrated 8-bit serial peripheral interface (SPI) is used for a synchronous serial

communication between the host microprocessor (always master) and the L6482 (always

slave).

The SPI uses chip select (CS), serial clock (CK), serial data input (SDI) and serial data

output (SDO) pins. When CS is high the device is unselected and the SDO line is inactive

(high impedance).

The communication starts when CS is forced low. The CK line is used for synchronization of

data communication.

All commands and data bytes are shifted into the device through the SDI input, most

significant bit first. The SDI is sampled on the rising edges of the CK.

All output data bytes are shifted out of the device through the SDO output, most significant

bit first. The SDO is latched on the falling edges of the CK. When a return value from the

device is not available, an all zero byte is sent.

After each byte transmission the CS input must be raised and be kept high for at least tdisCS

in order to allow the device to decode the received command and put the return value into

the shift register.

All timing requirements are shown in Figure 23 (see Section 3 for values).

Multiple devices can be connected in daisy chain configuration, as shown in Figure 24.

Figure 23.

SPI timings diagram

AM15053v1

SDI

SDO

MSBLSB

LSB

N-1

N-2

MSB

HiZ

N-1

N-2

tsetCS

tenSDO

tsetSDI

tholSDI

tvSDO

tholSDO

trCK

tfCK

thCK

tlCK

tdisSDO

tholCS

tdisCS

MSB

L6482 Datasheet(PDF) 41 Page - STMicroelectronics

L6482 Datasheet(HTML) 41 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73

Datasheet Download

Link URL