DSPIC33FJ06GS201TESLASHMM datasheet(138/346 Pages) MICROCHIP

138 / 346 page

dsPIC33FJ06GS101/X02 and dsPIC33FJ16GSX02/X04

DS70318D-page 136

Preliminary

8.1

CPU Clocking System

The dsPIC33FJ06GS101/X02 and dsPIC33FJ16GSX02/

X04 devices provide six system clock options:

• Fast RC (FRC) Oscillator

• FRC Oscillator with PLL

• Primary (XT, HS or EC) Oscillator

• Primary Oscillator with PLL

• Low-Power RC (LPRC) Oscillator

• FRC Oscillator with Postscaler

8.1.1

SYSTEM CLOCK SOURCES

The Fast RC (FRC) internal oscillator runs at a nominal

frequency of 7.37 MHz. User software can tune the

FRC frequency. User software can optionally specify a

factor (ranging from 1:2 to 1:256) by which the FRC

clock frequency is divided. This factor is selected using

the FRCDIV<2:0> (CLKDIV<10:8>) bits.

The primary oscillator can use one of the following as

its clock source:

• XT (Crystal): Crystals and ceramic resonators in

the range of 3 MHz to 10 MHz. The crystal is

connected to the OSC1 and OSC2 pins.

• HS (High-Speed Crystal): Crystals in the range of

10 MHz to 40 MHz. The crystal is connected to

the OSC1 and OSC2 pins.

• EC (External Clock): The external clock signal is

directly applied to the OSC1 pin.

The LPRC internal oscIllator runs at a nominal

frequency of 32.768 kHz. It is also used as a reference

clock by the Watchdog Timer (WDT) and Fail-Safe

Clock Monitor (FSCM).

The clock signals generated by the FRC and primary

oscillators can be optionally applied to an on-chip

Phase-Locked Loop (PLL) to provide a wide range of

output

frequencies

for

device

operation.

PLL

configuration is described in Section 8.1.3 “PLL Con-

figuration”

The FRC frequency depends on the FRC accuracy

(see Table 24-20) and the value of the FRC Oscillator

Tuning register (see Register 8-4).

8.1.2

SYSTEM CLOCK SELECTION

The oscillator source used at a device Power-on Reset

event is selected using Configuration bit settings. The

oscillator Configuration bit settings are located in the

Configuration registers in the program memory. (Refer

to Section 21.1 “Configuration Bits” for further

details.) The Initial Oscillator Selection Configuration

bits, FNOSC<2:0> (FOSCSEL<2:0>), and the Primary

Oscillator

Mode

Select

Configuration

bits,

POSCMD<1:0> (FOSC<1:0>), select the oscillator

source that is used at a Power-on Reset. The FRC

primary oscillator is the default (unprogrammed)

selection.

The Configuration bits allow users to choose among

12 different clock modes, shown in Table 8-1.

The output of the oscillator (or the output of the PLL if

a PLL mode has been selected), FOSC, is divided by 2

to generate the device instruction clock (FCY) and the

peripheral clock time base (FP). FCY defines the

operating speed of the device and speeds up to 40

MHz are supported by the dsPIC33FJ06GS101/X02

and dsPIC33FJ16GSX02/X04 architecture.

Instruction execution speed or device operating

frequency, FCY, is given by Equation 8-1.

EQUATION 8-1:

DEVICE OPERATING

FREQUENCY

TABLE 8-1:

CONFIGURATION BIT VALUES FOR CLOCK SELECTION

FCY = FOSC/2

Oscillator Mode

Oscillator Source POSCMD<1:0>

FNOSC<2:0>

Note

Fast RC Oscillator with Divide-by-N (FRCDIVN)

Internal

111

1, 2

Fast RC Oscillator with Divide-by-16 (FRCDIV16)

Internal

110

Low-Power RC Oscillator (LPRC)

Internal

101

Reserved

100

—

Primary Oscillator (HS) with PLL (HSPLL)

Primary

011

—

Primary Oscillator (XT) with PLL (XTPLL)

Primary

011

—

Primary Oscillator (EC) with PLL (ECPLL)

Primary

011

Primary Oscillator (HS)

Primary

010

—

Primary Oscillator (XT)

Primary

010

—

Primary Oscillator (EC)

Primary

010

Fast RC Oscillator with PLL (FRCPLL)

Internal

001

Fast RC Oscillator (FRC)

Internal

000

Note 1:

OSC2 pin function is determined by the OSCIOFNC Configuration bit.

This is the default oscillator mode for an unprogrammed (erased) device.

DSPIC33FJ06GS201TE/MM Datasheet(PDF) 138 Page - Microchip Technology

DSPIC33FJ06GS201TE/MM Datasheet(HTML) 138 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL