AN4092 datasheet(14/38 Pages) STMICROELECTRONICS

14 / 38 page

Power Management Controller (PMC)

AN4092

14/38

Doc ID 023080 Rev 2

For EMC reasons, decoupling capacitors are connected to the VDD and VSS of adjacent

pins. This is illustrated by Figure 6.

Figure 6.

Implementation of decoupling Capacitors

Do not place one or more caps close to the transistor emitter in order to avoid potential

resonant CLC network (emitter cap(s) -> parasitic inductance -> VDD caps).

1.2

External power supply configuration

In this configuration the three voltage levels required are provided externally: VRCCTL can

be left floating, VRC33 becomes the input of the 3.3 voltage and VDD pins/balls must be

connected to the 1.2 V source.

In order to switch off the internal 3.3 voltage regulator, two solutions are possible:

VDDREG = GND

Disabling the regulator using this option implies disabling also the Low Voltage Inhibit circuit.

SPC564Axx

vrc3p3_shutdown_shadow_bit = 0 (bit 31, least significant bit) in the FLASH_BIU4

The default value after reset of the volatile register FLASH_BIU4 can be modified by

programming the shadow FLASH location 0x00FF_FE10.

SPC563Mxx

V33EN = 0

The internal 3.3 V regulator is always switched on during reset.

AN4092 Datasheet(PDF) 14 Page - STMicroelectronics