AN3114 datasheet(40/43 Pages) STMICROELECTRONICS

40 / 43 page

LCD segment drive firmware

AN3114

40/43

Doc ID 16829 Rev 3

5.2.1

LCD controller setup

The following steps are recommended to configure the LCD controller:

Enable the LCD clock.

Configure the RTC clock source.

Configure the duty ratio and the bias.

Configure the frame frequency in the operating frequency range of the LCD glass, that

is between 20 and 85 Hz.

Configure the voltage source.

Configure the port mask registers according to the pins used as segment lines.

If the internal voltage source is selected, then adjust the contrast using the contrast

bits.

If the external voltage source is selected, then adjust the contrast using the dead time

bits.

The contrast can be adjusted also using the pulse on duration bits.

10. Enable the LCD controller.

In this application, the LCD controller is configured as follows:

●

LCD clock source frequency

fLCDCLK = LSE frequency = 32.768 KHz

●

Prescaler factor = 2

●

Divider factor = 18 (16 + 2)

●

Mode = 1/4 Duty, 1/3 Bias applies to medium density STM8L152xx devices (PD-878

LCD Glass) and Mode = 1/8 Duty, 1/4 Bias applies to high density

STM8L152xx/STM8L162xx devices (HXO5002B custom LCD glass)

●

LCD clock frequency

The LCD clock frequency, fframe, is given by the equation below:

As a result, if fck_div equals 228 Hz, fframe = 57Hz for PD-878 LCD glass and fframe =

28.5 Hz for custom LCD glass HXO5002B.

frame

ck_divxduty

LCDCLK

x16

DIV

()

------------------------------------------xduty

AN3114 Datasheet(PDF) 40 Page - STMicroelectronics

AN3114 Datasheet(HTML) 40 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

Datasheet Download

Link URL