CMV2000 datasheet(5/64 Pages) AMSCO

5 / 64 page

Reference: CMV2000-datasheet-v3.8

CMV2000 v3 Datasheet

Page 4 of 63

Issue

Date

Modification

3.6

28/03/2014

Added:

All PLL registers are now in the register overview

Recommendation for unused pins

Note that fot_length register can be lowered for shorter integration times

Note that LVDS output current can be lowered for meeting EMC standards

Ordering information now includes part numbers for all packages

Updated:

Corrected some register addresses in the register overview

LCC spec was listed as 95 pins, should be 92

Description of settling time should be more clear now, added typical values

Description of start-up and reset sequence

Description of PGA settings should be more clear now

Description of register optimization is now more complete

Improved some layout issues

Corrected table in Chapter 5.2.2.1: Vlow3 wrongly referred to Vlow2

PLL registers in register overview: bit locations were not always correct

Pin list table is now sorted on function, rather than pin coordinate

New figures for glass transmittance, QE and response

“color” register is now called “mono” because it better fits the functionality

Removed:

Recommended setting of “0” for i_lvds_rec was causing confusion

Pixel coordinates on block diagram

3.7

28/01/2015

Updated:

The power figure in the Specification Overview is now more accurate; it

considers the sensor configuration

The exposure time is shortest in external exposure mode, so this mode is

added to the calculation.

FRAME_REQ is level sensitive, not edge sensitive

Maximum number of frames is 65535, not 65548

Corrected note that said that the exposure starts directly after F_REQ, there

is a delay between the two

Corrected calibration procedure, step 2 should be repeated, not step 1.

Removed

Nr_slopes2 register from overview, this is an unused register

Scratch/dig/bubble spec for cover glass

3.8

18/06/2015

Updated:

LCC pin layout now correctly says it’s the bottom view, not the top

LCC Product number now for AR coated glass only

Added

Transmittance curve for AR coated glass

Disclaimer

CMOSIS reserves the right to change the product, specification and other information contained in this document

without notice. Although CMOSIS does its best efforts to provide correct information, this is not warranted.

CMV2000 Datasheet(PDF) 5 Page - ams AG

CMV2000 Datasheet(HTML) 5 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Datasheet Download

Link URL