PC7410 datasheet(9/54 Pages) ATMEL

9 / 54 page

PC7410

2141D–HIREL–02/04

Detailed Specification

Scope

This drawing describes the specific requirements for the microprocessor PC7410 in

compliance with Atmel-Grenoble standard screening.

Applicable

Documents

MIL-STD-883: Test methods and procedures for electronics

MIL-PRF-38535: Appendix A: General specifications for microcircuits

Requirements

General

The microcircuits are in accordance with the applicable documents and as specified

herein.

Design and Construction

Terminal Connections

Depending on the package, the terminal connections are as shown in Table 16, Table 4

and Figure 2.

Absolute Maximum

Ratings

Notes:

1. Functional and tested operating conditions are given in Table 4. Absolute maximum ratings are stress ratings only. Stresses

beyond those listed may affect device reliability or cause permanent damage to the device.

2. Caution: V

IN must not exceed OVDD or L2OVDD by more than 0.2V at any time including during power-on reset.

3. Caution: L2OV

DD/OVDD must not exceed VDD/AVDD/L2AVDD by more than 2.0V at any time including during power-on reset;

this limit may be exceeded for a maximum of 20 ms during power-on reset and power-down sequences.

4. Caution: V

DD/AVDD/L2AVDD must not exceed L2OVDD/OVDD by more than 0.4V at any time including during power-on reset;

this limit may be exceeded for a maximum of 20 ms during power-on reset and power-down sequences.

5. VIN may overshoot/undershoot to a voltage and for a maximum duration as shown in Figure 3.

6. PC7410RXnnnLE (Rev 1.4) and later only. Previous revisions do not support 3.3V OV

DD and have a maximum value OVDD of

-0.3 to 2.6V.

Table 2. Absolute Maximum Ratings

(1)

Symbol

Characteristic

Value

Unit

Core supply voltage

-0.3 to 2.1(4)

AVDD

PLL supply voltage

-0.3 to 2.1(4)

L2AV

L2 DLL supply voltage

-0.3 to 2.1(4)

60x bus supply voltage

-0.3 to 3.465(3)(6)

L2OVDD

L2 bus supply voltage

-0.3 to 2.6(3)

Processor bus input voltage

-0.3 to OVDD + 0,2V(2)(5)

L2 bus input voltage

-0.3 to L2OVDD + 0,2V(2)(5)

VIN

JTAG signal input voltage

-0.3 to OVDD + 0,2V

STG

Storage temperature range

-55 to 150

°C

Rework temperature

260

°C

PC7410 Datasheet(PDF) 9 Page - ATMEL Corporation

PC7410 Datasheet(HTML) 9 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54

Datasheet Download

Link URL