ACE25QC160GLDPTH datasheet(59/73 Pages) ACE

59 / 73 page

ACE25QC160G

16M BIT SPI NOR FLASH

VER 1.2

Erase / Program Suspend (75H)

The Erase/Program Suspend instruction allows the system to interrupt a Sector or Block Erase operation,

then read from or program data to any other sector. The Erase/Program Suspend instruction also allows

the system to interrupt a Page Program operation and then read from any other page or erase any other

sector or block. The Erase/Program Suspend instruction sequence is shown in Figure 39.a (SPI mode) &

Figure 39.b (QPI mode)

The Write Status Registers instruction (01h) and Erase instructions (20h, D8h, C7h, 60h, 44h) are not

allowed during Erase Suspend. Erase Suspend is valid only during the Sector or Block erase operation. If

written during the Chip Erase operation, the Erase Suspend instruction is ignored. The Write Status

Registers instruction (01h), and Program instructions (02h, 42h) are not allowed during Program Suspend.

Program Suspend is valid only during the Page Program operation.

Figure 39.a. Erase/Program Suspend Command Sequence (SPI mode)

Figure 39.b. Program/Erase Suspend Instruction (QPI Mode)

ACE25QC160GLDPTH Datasheet(PDF) 59 Page - ACE Technology Co., LTD.