DAC8760IPWPR.B datasheet(32/69 Pages) TI2

32 / 69 page

0.00

Supply (V)

Specified Supply

Voltage Range

No Power-On Reset

Supply Max.

Supply Min.

Power-On Reset

POR Threshold

Undefined

Undefined Operation Threshold

Figure 8-4. Relevant Voltage Levels for POR Circuit

For the DVDD supply, no internal POR occurs for nominal supply operation from 2.7 V (supply minimum) to 5.5

V (supply maximum). For the DVDD supply region between 2.4 V (undefined operation threshold) and 0.8 V

(POR threshold), the internal POR circuit may or may not provide a reset over all temperature conditions. For the

DVDD supply below 0.8 V (POR threshold), the internal POR resets as long as the supply voltage is below 0.8 V

for approximately 1 ms.

For the AVDD supply, no internal POR occurs for nominal supply operation from 10 V (supply minimum) to

36 V (supply maximum). For AVDD supply voltages between 8 V (undefined operation threshold) to 1 V (POR

threshold), the internal POR circuit may or may not provide a reset over all temperature conditions. For the

AVDD supply below 1 V (POR threshold), the internal POR resets as long as the supply voltage is below 1 V

for approximately 1 ms. In case the DVDD or AVDD supply drops to a level where the internal POR signal is

indeterminate, either power cycle the device or toggle the LATCH pin followed by a software reset. Both options

initialize the internal circuitry to a known state and provide proper operation.

8.3.8 Alarm Detection

The device also provides an alarm detection feature. When one or more of following events occur, the ALARM

pin goes low:

• The current output load is in open circuit; or

• The voltage at IOUT reaches a level where the accuracy of the output current is compromised. This condition

is detected by monitoring internal voltage levels of the IOUT circuitry and is typically below the specified

compliance voltage headroom (defined as the voltage drop between the AVDD and IOUT pins) minimum of 2

V; or

• The die temperature has exceeded 142°C; or

• The SPI watchdog timer exceeded the timeout period (if enabled); or

• The SPI frame error CRC check encountered an error (if enabled).

When the ALARM pins of multiple DACx760 devices are connected together to form a wired-AND function, the

host processor must read the status register of each device to know all the fault conditions that are present.

Note that the thermal alarm has hysteresis of about 18°C. After being set, the alarm only resets when the die

temperature drops below 124°C.

DAC7760, DAC8760

SBAS528D – JUNE 2013 – REVISED DECEMBER 2021

www.ti.com

Submit Document Feedback

Product Folder Links: DAC7760 DAC8760

DAC8760IPWPR.B Datasheet(PDF) 32 Page - Texas Instruments

DAC8760IPWPR.B Datasheet(HTML) 32 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69

Datasheet Download

Link URL