68HC705SP7 datasheet(76/230 Pages) FREESCALE

76 / 230 page

Operating Modes

General Release Specification

MC68HC705JJ7/MC68HC705JP7 — Rev. 3.0

Operating Modes

6.4.3 Halt Mode

The STOP instruction puts the MCU in halt mode if selected by the

SWAIT bit in the MOR. Halt mode is identical to wait mode, except that

a variable recovery delay occurs when the MCU exits halt mode. A

recovery time of from 1 to 16 or from 1 to 4064 internal bus cycles can

be selected by the DELAY bit in the MOR.

If the SWAIT bit is set in the MOR to put the MCU in halt mode, the COP

watchdog cannot be turned off inadvertently by a STOP instruction.

6.4.4 Data-Retention Mode

In the data-retention mode, the MCU retains RAM contents and CPU

feature allows the MCU to remain in a low-power consumption state

during which it retains data, but the CPU cannot execute instructions.

To put the MCU in the data retention mode:

1. Drive the RESET pin to a logic zero.

2. Lower the VDD voltage. The RESET pin must remain low

continuously during data retention mode.

To take the MCU out of the data retention mode:

1. Return VDD to normal operating voltage.

2. Return the RESET pin to a logic one.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

68HC705SP7 Datasheet(PDF) 76 Page - Freescale Semiconductor, Inc