| Electronic Components Datasheet Search |
|
56F8322 Datasheet(PDF) 91 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
56F8322 Datasheet(HTML) 91 Page - Freescale Semiconductor, Inc |
|
91 / 136 page ![]() Register Descriptions 56F8322 Technical Data, Rev. 16 Freescale Semiconductor 91 Preliminary 6.5.9.10 Serial Communications Interface 1 Enable (SCI1)—Bit 5 Each bit controls clocks to the indicated peripheral. • 1 = Clocks are enabled • 0 = The clock is not provided to the peripheral (the peripheral is disabled) 6.5.9.11 Serial Communications Interface 0 Enable (SCI0)—Bit 4 Each bit controls clocks to the indicated peripheral. • 1 = Clocks are enabled • 0 = The clock is not provided to the peripheral (the peripheral is disabled) 6.5.9.12 Serial Peripheral Interface 1 Enable (SPI1)—Bit 3 Each bit controls clocks to the indicated peripheral. • 1 = Clocks are enabled • 0 = The clock is not provided to the peripheral (the peripheral is disabled) 6.5.9.13 Serial Peripheral Interface 0 Enable (SPI0)—Bit 2 Each bit controls clocks to the indicated peripheral. • 1 = Clocks are enabled • 0 = The clock is not provided to the peripheral (the peripheral is disabled) 6.5.9.14 Reserved—Bit 1 This bit field is reserved or not implemented. It is read as 1 and cannot be modified by writing. 6.5.9.15 Pulse Width Modulator A Enable (PWMA)—Bit 0 Each bit controls clocks to the indicated peripheral. • 1 = Clocks are enabled • 0 = The clock is not provided to the peripheral (the peripheral is disabled) 6.5.10 I/O Short Address Location Register (SIM_ISALH and SIM_ISALL) The I/O Short Address Location registers are used to specify the memory referenced via the I/O short address mode. The I/O short address mode allows the instruction to specify the lower six bits of address; the upper address bits are not directly controllable. This register set allows limited control of the full address, as shown in Figure 6-13. Note: If this register is set to something other than the top of memory (EOnCE register space) and the EX bit in the OMR is set to 1, the JTAG port cannot access the on-chip EOnCE registers, and debug functions will be affected. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |