IO96NDB2V1 datasheet(240/242 Pages) MICROSEMI

240 / 242 page

Datasheet Information

5-8

Revision 13

Datasheet Categories

Categories

In order to provide the latest information to designers, some datasheet parameters are published before

data has been fully characterized from silicon devices. The data provided for a given device, as

highlighted in the "ProASIC3L Device Status" table on page IV, is designated as either "Product Brief,"

"Advance," "Preliminary," or "Production." The definitions of these categories are as follows:

Product Brief

The product brief is a summarized version of a datasheet (advance or production) and contains general

product information. This document gives an overview of specific device and family information.

Advance

This version contains initial estimated information based on simulation, other products, devices, or speed

grades. This information can be used as estimates, but not for production. This label only applies to the

DC and Switching Characteristics chapter of the datasheet and will only be used when the data has not

been fully characterized.

Preliminary

The datasheet contains information based on simulation and/or initial characterization. The information is

believed to be correct, but changes are possible.

Production

This version contains information that is considered to be final.

Export Administration Regulations (EAR)

The products described in this document are subject to the Export Administration Regulations (EAR).

They could require an approved export license prior to export from the United States. An export includes

release of product or disclosure of technology to a foreign national inside or outside the United States.

Safety Critical, Life Support, and High-Reliability Applications

Policy

The products described in this advance status document may not have completed the Microsemi

qualification process. Products may be amended or enhanced during the product introduction and

qualification process, resulting in changes in device functionality or performance. It is the responsibility of

each customer to ensure the fitness of any product (but especially a new product) for a particular

purpose, including appropriateness for safety-critical, life-support, and other high-reliability applications.

Consult the Microsemi SoC Products Group Terms and Conditions for specific liability exclusions relating

to life-support applications. A reliability report covering all of the SoC Products Group’s products is

available at http://www.microsemi.com/soc/documents/ORT_Report.pdf. Microsemi also offers a variety

of enhanced qualification and lot acceptance screening procedures. Contact your local sales office for

additional reliability information.

IO96NDB2V1 Datasheet(PDF) 240 Page - Microsemi Corporation