UCS1002-3 datasheet(75/114 Pages) MICROCHIP

75 / 114 page

 2023 Microchip Technology Inc. and its subsidiaries

DS20006852A-page 75

UCS1002-3

(ADDRESS 35h)(Note 1)

U-x

R-0

—

S2_TD_TYPE

S2_TD[2:0]

STIM2[2:0]

bit 7

bit 0

Legend:

R = Readable bit

W = Writable bit

U = Unimplemented bit

-n = Value at POR

‘1’ = Bit is set

‘0’ = Bit is cleared

x = Bit is unknown

bit 7

Unimplemented

bit 6

S2_TD_TYPE: Determines the behavior of the stimulus timer.

1 = The stimulus timer controls how long the response is applied after the stimulus is detected. The

response is immediately applied and held for the duration of the timer, and then removed if the

stimulus is removed.

0 = The stimulus timer is a delay from when the stimulus is detected until the response is performed.

bit 5-3

S2_TD[2:0]: Determines the Stimulus 2 tSTIM_DEL value as shown below.

000 =0 ms

001 =1 ms

010 =5 ms

011 =10 ms

100 =20 ms

101 =40 ms

110 =80 ms

111 = 100 ms

bit 2-0

STIM2[2:0]: Determines the Stimulus 2 that is used as shown below. Note that the lower threshold for

the window comparator option is fixed at 400 mV and only applies to the DPOUT pin. This setting cannot

be used for the DMOUT port.

000 = VBUS voltage ready to be applied before port power switch is closed. Next stimulus does not wait

for this to be removed.

001 = DPOUT voltage is greater than the threshold (S2_TH).

010 = Window comparator. DPOUT voltage is lower than the threshold (S2_TH) and DPOUT voltage

greater than the fixed threshold.

011 =DMOUT voltage is greater than the threshold (S2_TH).

100 = Do not use.

101 = Do not use.

110 = DPOUT voltage is greater than the threshold (S2_TH).

111 = Voltage is present after the port power switch is closed. Next stimulus does not wait for this to

be removed.

Note 1: The Legacy charger emulation profiles do not use these settings. Whenever a Legacy charger emulation

profile is applied within the DCE Cycle, these controls will not be updated and should be ignored. These

settings are only used by the BC1.2 CDP and BC1.2 DCP charger emulation profiles.

UCS1002-3 Datasheet(PDF) 75 Page - Microchip Technology

UCS1002-3 Datasheet(HTML) 75 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL