COP8CCR9IMT7SLASHNOPB datasheet(45/111 Pages) TI1

45 / 111 page

COP8CBR9, COP8CCR9, COP8CDR9

www.ti.com

SNOS535I – OCTOBER 2000 – REVISED MARCH 2013

The underflows can be programmed to toggle the TxA output pin. The underflows can also be

programmed to generate interrupts.

Underflows from the timer are alternately latched into two pending flags, TxPNDA and TxPNDB. The user

must reset these pending flags under software control. Two control enable flags, TxENA and TxENB,

allow the interrupts from the timer underflow to be enabled or disabled. Setting the timer enable flag

TxENA will cause an interrupt when a timer underflow causes the RxA register to be reloaded into the

timer. Setting the timer enable flag TxENB will cause an interrupt when a timer underflow causes the RxB

interrupts.

Either or both of the timer underflow interrupts may be enabled. This gives the user the flexibility of

interrupting once per PWM period on either the rising or falling edge of the PWM output. Alternatively, the

user may choose to interrupt on both edges of the PWM output.

Figure 5-10. Timer in PWM Mode

5.11.2.3 Mode 2. External Event Counter Mode

This mode is quite similar to the processor independent PWM mode described above. The main difference

is that the timer, Tx, is clocked by the input signal from the TxA pin after synchronization to the

appropriate internal clock (tC or MCLK). The Tx timer control bits, TxC3, TxC2 and TxC1 allow the timer to

be clocked either on a positive or negative edge from the TxA pin. Underflows from the timer are latched

into the TxPNDA pending flag. Setting the TxENA control flag will cause an interrupt when the timer

underflows.

In this mode the input pin TxB can be used as an independent positive edge sensitive interrupt input if the

TxENB control flag is set. The occurrence of a positive edge on the TxB input pin is latched into the

TxPNDB flag.

Figure 5-11 shows a block diagram of the timer in External Event Counter mode.

NOTE

The PWM output is not available in this mode since the TxA pin is being used as the counter

input clock.

Functional Description

Submit Documentation Feedback

Product Folder Links: COP8CBR9 COP8CCR9 COP8CDR9

COP8CCR9IMT7/NOPB Datasheet(PDF) 45 Page - Texas Instruments