| Electronic Components Datasheet Search |
|
LTM4677 Datasheet(PDF) 72 Page - Analog Devices |
|
|
|||||||||||||||||||||||||||||
LTM4677 Datasheet(HTML) 72 Page - Analog Devices |
|
72 / 110 page ![]() LTC3888-1 72 Rev. 0 For more information www.analog.com PMBUS_REVISION The PMBUS_REVISION command returns the revision of the PMBus Specification that the device supports. The LTC3888-1 is compliant with PMBus Version 1.2, both Part I and Part II. This read-only command has one data byte. CAPABILITY The CAPABILITY command reports some key LTC3888-1 features to the PMBus host device. The LTC3888-1 supports packet error checking, 400kHz bus speeds and has an ALERT output. This read-only command has one data byte. GENERAL DEVICE CONFIGURATION COMMAND NAME CMD CODE DESCRIPTION TYPE PAGED DATA FORMAT UNITS NVM DEFAULT VALUE PMBUS_REVISION 0x98 Supported PMBus version. R Byte Y Reg 0x22 V1.2 CAPABILITY 0x19 Summary of supported optional PMBus features. R Byte N Reg 0xB0 MFR_CONFIG_ALL 0xD1 General device-level configuration. R/W Byte N Reg l 0x21 MFR_ADDRESS The MFR_ADDRESS command sets the seven bits of the PMBus device address for this unit. Setting this command to a value of 0x80 disables device-level addressing. The global device addresses 0x5A and 0x5B cannot be disabled. The LTC3888-1 always responds at these addresses. The device address, or any portion of an address, specified with external resistors on ASEL0 or ASEL1 is applied. If both of these pins are open, the device address is determined strictly by the MFR_ADDRESS value stored in EEPROM. Refer to the Operation section on Resistor Configuration Pins for additional details. This command has one data byte. MFR_RAIL_ADDRESS The MFR_RAIL_ADDRESS command sets a direct PMBus address for the active channel(s) as determined by the PAGE command. This address should be common to all master channels attached to a single power supply rail. Setting this command to a value of 0x80 disables rail addressing for the selected channel. Only command writes should be made to the rail address. If a read is performed from this address, a CML fault may result. This command has one data byte. PMBus COMMAND DETAILS (Addressing and Write Protect/General Device Configuration) |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |