 |
Electronic Components Datasheet Search |
|
|
Electronic Components Datasheet Search |
|
GRM552B11H102KA01D Datasheet(PDF) 58 Page - Murata Manufacturing Co., Ltd. |
|
|
|||||||||||||||||||||||||||||
GRM552B11H102KA01D Datasheet(HTML) 58 Page - Murata Manufacturing Co., Ltd. |
|
|
58 / 221 page  *1: Nominal values denote the temperature coefficient within a range of 25 °C to 125°C (for ∆C)/85°C (for other TC). Continued from the preceding page. Apply 200%* of the rated voltage at the maximum operating temperature ±3°C for 1000±12 hours. Set for 24 ±2 hours at room temperature, then measure. The charge/discharge current is less than 50mA. •Initial measurement for high dielectric constant type. Apply 200% of the rated voltage* at the maximum operating temperature ±3°C for one hour. Remove and set for 24±2 hours at room temperature. Perform initial measurement. *GRM155C81E 683/104, GRM188C81E105, GRM188C81E105, GRM21BR71H105, GRM21BR72A474, GRM21BR71C225, GRM31CR71H475, GRM32E R6/R7 YA106, GRM32D R7/R6/C8 1E106 : 150% of the rated voltage. 18 High Temperature Load The measured and observed characteristics should satisfy the specifications in the following table. Appearance No defects or abnormalities Capacitance Change Within ±3% or ±0.3pF (whichever is larger) B1, B3, R1, R6, R7, C8: Within ±12.5% F1, F5, E4: Within ±30% [Except 10V max. and. C U1.0µF] F1, F5: Within +30/–40% [10V max. and C U1.0µF] Q/D.F. 30pF and over: Q U350 10pF and over 30pF and below: Q U275+2.5C 10pF and below: Q U200+10C C: Nominal Capacitance (pF) [B1, B3, R6, R7, C8] W.V.: 100V : 0.05 max. (C F0.068µF) : 0.075 max. (C U0.068µF) W.V.: 50/35/25/16/10V : 0.05 max. W.V.: 6.3/4V : 0.075 max. (C F3.3µF) : 0.125 max. (C U3.3µF) [E4] W.V.: 25Vmin: 0.05 max. [F1, F5] W.V.: 25V min. : 0.075 max.(C F0.1µF) : 0.125 max.(C U0.1µF) W.V.: 16/10V: 0.15 max. W.V.: 6.3V: 0.2 max. I.R. More than 1,000M Ω or 50Ω · F (whichever is smaller) No. Test Method Specifications Temperature Compensating Type High Dielectric Type Item Char. +350 to –1000 Max. Nominal Values (ppm/ °C)*1 –55 0.58 0.87 2.33 3.02 4.09 5.46 8.78 – Min. –0.24 –0.48 0.72 1.28 2.16 3.28 5.04 – Max. –30 Capacitance Change from 25 °C (%) 0.40 0.59 1.61 2.08 2.81 3.75 6.04 – Min. –0.17 –0.33 0.50 0.88 1.49 2.26 3.47 – Max. –10 0.25 0.38 1.02 1.32 1.79 2.39 3.84 – Min. –0.11 –0.21 0.32 0.56 0.95 1.44 2.21 – 5C 6C 6P 6R 6S 6T 7U 1X Table A-1 (1) *2: Nominal values denote the temperature coefficient within a range of 20 °C to 125°C (for ∆C)/85°C (for other TC). Char. Max. Nominal Values (ppm/ °C)*2 –55 0.82 1.37 2.56 – – – – – – – – – – – – – – Min. –0.45 –0.90 –1.88 – – – – – – – – – – – – – – Max. –25 Capacitance Change from 20 °C (%) 0.49 0.82 1.54 1.32 1.65 2.36 1.70 2.03 2.74 2.30 2.63 3.35 3.07 3.40 4.12 4.94 5.65 Min. –0.27 –0.54 –1.13 0.41 0.14 –0.45 0.72 0.45 –0.14 1.22 0.95 0.36 1.85 1.58 0.99 2.84 2.25 Max. –10 0.33 0.55 1.02 0.88 1.10 1.57 1.13 1.35 1.83 1.54 1.76 2.23 2.05 2.27 2.74 3.29 3.77 Min. –0.18 –0.36 –0.75 0.27 0.09 –0.30 0.48 0.30 –0.09 0.81 0.63 0.24 1.23 1.05 0.66 1.89 1.50 2C 3C 4C 2P 3P 4P 2R 3R 4R 2S 3S 4S 2T 3T 4T 3U 4U (2) GRM Series Specifications and Test Methods (1) (Note 1)-Typical Inspection ±30 ±60 ±60 ±60 ±60 ±60 ±120 0 0 –150 –220 –330 –470 –750 0 0 0 –150 –150 –150 –220 –220 –220 –330 –330 –330 –470 –470 –470 –750 –750 ±60 ±120 ±250 ±60 ±120 ±250 ±60 ±120 ±250 ±60 ±120 ±250 ±60 ±120 ±250 ±120 ±250 GRM Series Specifications and Test Methods (1) (Note 1)-Typical Inspection 56 !Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc. • This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering. (Note 1) These Specifications and Test Methods indicate typical inspection. Please refer to individual specifications (our product specifications or the approval sheet). When no "*" is added in PNs table, please refer to GRM Series Specifications and Test Methods (1). When "*" is added in PNs table, please refer to GRM Series Specifications and Test Methods (2). • This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering. • This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering. !Note C02E.pdf 10.12.20 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
English ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
