MB95F613K datasheet(77/110 Pages) CYPRESS

77 / 110 page

Document Number: 002-04698 Rev. *A

Page 77 of 110

PRELIMINARY

MB95610H Series

18.2 Recommended Operating Conditions

(VSS = 0.0 V)

*1: The minimum power supply voltage becomes 2.88 V when a product with the low-voltage detection reset is used or when the

on-chip debug mode is used.

*2: Use a ceramic capacitor or a capacitor with equivalent frequency characteristics. The decoupling capacitor for the VCC pin must

have a capacitance equal to or larger than the capacitance of CS. For the connection to a decoupling capacitor CS, see the diagram

below. To prevent the device from unintentionally entering an unknown mode due to noise, minimize the distance between the C

pin and CS and the distance between CS and the VSS pin when designing the layout of a printed circuit board.

WARNING:

The recommended operating conditions are required in order to ensure the normal operation of the semiconductor

device. All of the device's electrical characteristics are warranted when the device is operated under these conditions.

Any use of semiconductor devices will be under their recommended operating condition.

Operation under any conditions other than these conditions may adversely affect reliability of device and could result

in device failure.

No warranty is made with respect to any use, operating conditions or combinations not represented on this data sheet.

If you are considering application under any conditions other than listed herein, please contact sales representatives

beforehand.

Parameter

Symbol

Value

Unit

Remarks

Min

Max

Power supply voltage

VCC

2.4*1

5.5

In normal operation

2.3

5.5

Hold condition in stop mode

Decoupling capacitor

0.022

µF

Operating temperature

 40

85

C

Not in on-chip debug mode

5

35

In on-chip debug mode

DBG

RST

• DBG / RST / C pins connection diagram

*: Connect the DBG pin to an external pull-up resistor of 2 k

 or above. After power-on, ensure that the

DBG pin does not stay at “L” level until the reset output is released. The DBG pin becomes a com-

munication pin in debug mode. Since the actual pull-up resistance depends on the tool used and the

interconnection length, refer to the tool document when selecting a pull-up resistor.

MB95F613K Datasheet(PDF) 77 Page - Cypress Semiconductor

MB95F613K Datasheet(HTML) 77 Page - Cypress Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL