| Electronic Components Datasheet Search |
|
DS20006554A Datasheet(PDF) 35 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
DS20006554A Datasheet(HTML) 35 Page - Microchip Technology |
|
35 / 94 page ![]() ZL30260-ZL30263 Data Sheet 35 © 2021 Microchip Technology Inc. DS20006554A Register Name: MCR1 Register Description: Master Configuration Register 1 Register Address: 01h Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Name SRST HRST STOP — ROSCD AINCDIS ODMISO — Default 0 0 0 0 0 0 0 0 Bit 7: Soft Reset (SRST). This bit resets the entire device except for the microprocessor interface, the SRST bit itself, the MCR1.HRST bit, the I2CA register, and CFGSR bits 5:0. When SRST is active, the register fields with pin- programmed defaults do not latch their values from the corresponding input pins. When the SRST bit is asserted the device’s auto-configuration boot controller is not started. See section 5.9. 0 = Normal operation 1 = Reset Bit 6: Hard Reset (HRST). Asserting this bit is functionally equivalent to asserting the RSTN pin. The HRST bit resets the entire device except for the microprocessor interface and the HRST bit itself. Register fields with pin- programmed defaults latch their values from the corresponding input pins , and the device’s auto-configuration boot controller is started. See section 5.9. 0 = Normal operation 1 = Reset Bit 5: Output Clock Stop (STOP). Asserting this bit stops all output clocks that are configured with OCxSTOP.SRC=0001. Note that this signal is ORed with the per-output stop control bit in the STOPCR registers to make each output’s internal stop control signal. See section 5.6.7. Bit 3: Ring Oscillator Disable (ROSCD). This bit disables the ring oscillator. It can be set to 1 when auto- configuration is complete. See section 5.3.4. 0 = Enable 1 = Disable (power-down) Bit 1: Open Drain MISO Enable (ODMISO). This bit configures the MISO pin to be open-drain. When this bit is set, the MISO pin only drives low and must have an external pullup resistor. 0 = Disable (MISO drives 0 and 1, high-impedance when not driven) 1 = Enable (MISO drives 0 only, high-impedance all other times) |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |