STM32U375CE datasheet(195/222 Pages) STMICROELECTRONICS

195 / 222 page

Notes

1. Dimensioning and tolerancing schemes conform to ASME Y14.5M-1994.

2. The top package body size may be smaller than the bottom package size by as much as 0.15 mm.

3. Datums A-B and D to be determined at datum plane H.

4. To be determined at seating datum plane C.

5. Dimensions D1and E1 do not include mold flash or protrusions. Allowable mold flash or protrusions is “0.25

mm” per side. D1 and E1 are Maximum plastic body size dimensions including mold mismatch.

6. Details of pin 1 identifier are optional but must be located within the zone indicated.

7. All dimensions are in millimeters.

8. No intrusion allowed inwards the leads.

9. Dimension “b” does not include dambar protrusion. Allowable dambar protrusion shall not cause the lead width

to exceed the maximum “b” dimension by more than 0.08 mm. Dambar cannot be located on the lower radius

or the foot. Minimum space between protrusion and an adjacent lead is 0.07 mm for 0.4 mm and 0.5 mm pitch

packages.

10. Exact shape of each corner is optional.

11. These dimensions apply to the flat section of the lead between 0.10 mm and 0.25 mm from the lead tip.

12. A1 is defined as the distance from the seating plane to the lowest point on the package body.

13. “N” is the number of terminal positions for the specified body size.

14. Values in inches are converted from mm and rounded to 4 decimal digits.

15. Drawing is not to scale.

Figure 76. LQFP64 - Footprint example

1.2

0.3

10.3

12.7

10.3

0.5

7.8

12.7

1. Dimensions are expressed in millimeters.

STM32U375xx

Package information

DS14861 - Rev 2

page 195/222

STM32U375CE Datasheet(PDF) 195 Page - STMicroelectronics